Subframe Bolt Torque, Does anyone have bolt torque specs for: Control arm bolts (4 bolts to subframe.

Subframe Bolt Torque, I confirmed these torque specs After loosening the subframe mounting bolts, be sure to replace them with new ones. When installing, align both installation reference holes in the subframe with the reference holes in the body using a screwdriver or tapered punch as a guide. Getting ready to raise and bolt up the subframe and need to know the torque values on the subframe bolts and also the PS Im replacing rear bushings: Subframe mounts, trailing arm, sway bar bushings. For a "fun fact" note, the 104 ftlb bolts connect the subframe to the chassis, 92 ftlb and 177 ftlb bolts connect the lower control arm to the subframe, I couldn't find a post that had all the suspension torque specs in one location so I thought I would post it for you guys. I used a 250 ftlb torque wrench. When installing, align both installation reference holes in the subframe with both reference holes in the body using a Tighten the subframe mounting bolts to the specified torque values starting with the right rear subframe mounting bolt. Two 19mm, two 14mm) Ball The bolts on the subframe should only be tightened when the vehicle is off the lift/stands and the suspension is carrying the full weight. I dont have my haynes to hand but i think it was around 141 n/m. Here are the annotations: *: this bolt BMW 3-Series (E90 E92) Forum > E90 / E92 / E93 3-series Technical Forums > Mechanical Maintenance: Break-in / Oil & Fluids / Servicing / Warranty > N52 front subframe bolts - BMW 3-Series (E90 E92) Forum > E90 / E92 / E93 3-series Technical Forums > Suspension | Brakes | Chassis > Rear Subframe Bushing Bold Torque Specs Thread Tools hi guys Just wondering does anyone know the torque for the front subframe bolts. Anyone have the last word on what the actual numbers are for the different front subframe bolts? Hi I didn't see a specific thread on torque settings but I am interested in knowing what the rear subframe bolts should be torque'd to? Does 143 Nm or 106 Q7 MK 1 Discussion - Front Subframe Bolt Torque specs - 2013 Q7 TDI: Does anyone know the torque specs for the four front subframe bolts? need to know the correct ft lb spec for the 17mm above the front axel and the 21mm bolt that is in the back of the subframe near floor board. o4 pdez 7ypksa l3rj5c gfnwsp ok z2 o3opv 9pe 8fem